Idiomas disponibles
Idiomas disponibles
Operation
3.5 Operation environment
Height above sea level is below 1000m.
◆
Operation temperature range: -10˚C~+40˚C.
◆
Relative humidity is below 90% (20˚C).
◆
Preferably site the machine some angles above the floor level, the maximum angle
◆
does not exceed 15˚.
The content of dust,acid,corrosive gas in the surrounding air or substance can not
◆
exceed normal standard.
Take care that there is sufficient ventilation during welding.There is at least 30cm free
◆
disstance between the machine and wall.
3.6 Operation notices
Read safty instruction and Chapter 1 carefully before attempting to use this equipment.
◆
Connect the ground wire the machine directly.
◆
In case closing the power switch, no-load voltage may be exported.Do not touch the
◆
output electrode with any part of your body.
Before operation,no concerned people should be left,Do not watch the arc in
◆
unprotected eyes.
Ensure good ventilation of the machine to improve duty ratio.
◆
Turn off the engine when the operation finished to economize energy source.
◆
When power switch shuts off protectively because of failure.Don't restart it until
◆
until problem is resolved. Otherwise,the range of problem will be extended.
52
4.1 TIG basic welding technique
Gas Tungsten Arc Welding (GTAW) or TIG (Tungsten Inert Gas) as it is commonly referred
to, is a welding process in which fusion is produced by an electric arc that is established
between a single tungsten (non- consumable) electrode and the work piece. Shielding is
obtained from a welding grade shielding gas or welding grade shielding gas mixture which
is generally Argon based. A filler metal may also be added manually in some circumstances
depending on the welding application.
Gas Cup
Either Ceramic,
High-lmpact or
Water Cooled
Work Piece
can Be Any Commercial
Metal
Welds Made With or
Without Addition
of Filler Metal
TIG Welding Application Shot
4.2 Joint froms in TIG
a butt joint
b lap joint
4.3 The explanation of welding quality
The relation of welding area color & protect effect of stainless steel
Welding area color
argent,golden
Protect effect
best
The relation of welding area color & protect effect of Ti-alloy
Welding area color bright argent orange-yellow blue-purple caesious white powder
Protect effect
best
better
04
4.4 TIG parameters matching
The corresponding relationship between gas nozzle
diameter and electrode diameter
Welding technique
Metal
Tungsten Electrode
Non-Consumable
Inert Gas
Shields Electrode
and Weld Puddle
c coner joint
d T joint
red-grey
grey
blue
black
good
worst
better
bad
of titanium oxid
good
bad
worst
53
