Safety Instruction - Schulz ADS Serie Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. SAFETY INSTRUCTION

1. This equipment, if improperly used, can cause physical and material damage. To avoid these damages, follow the instructions below:
• This equipment may not be used by people with physical, sensorial, or mental handicaps. Or without experience or knowledge.
• People without the proper experience or knowledge may use this equipment only if properly supervised or instructed to it's use by so-
meone who is liable for his or her safety.
• Do not use your eqipment while tired, under the infl uence of medication, alcohol or drugs. Lack of attention during operation may result
in serious personal injury;
• Can cause mechanical or electrical interference on nearby sensitive equipments;
• Must be installed and operated in places that are ventilated and protected against moist presence and water falling.
2. The equipment model must be chosen in compliance with the established use. don't exceed maximun capacity, if required, acquire a
more suitable tool for the application. This will increase the effi ciency and safety in the work;
3. Always use suitable personal protective equipment (PPE), as each application, such as dust glasses and masks, non-skid safety shoes
and ear protection. This reduces the risks against personal injury;
4. Not use long wear clothing, or jewelry that may come into contact with the moving part of the tool during use. If you have long hair,
contain it before using the tool;
5. While in use, this equipment has electrical components and hot moving parts;
6. Compressed air is a highly hazardous energy source. Never work on the dryer with pressure in the system. Never point the compres-
sed air or the condensate drain outlet hoses towards anybody. The user is responsible for the proper installation of the dryer. Failure
to follow instructions given in the "Installation" chapter will void the warranty. Improper installation can create dangerous situations
for personnel and/or damages to the machine could occur.
7. The compressed air might contain pollutants that will cause harm to the health of humans, animals, ambient or foods, among
others. The compressed air must be treated with adequate filters, according to application and use requirements. Consult the
factory or a SCHULZ AUTHORIZED DEALER. for more information.
8. To reduce the risk of electrical shock;
• For protection against electric shock, it is recommended to install a residual current circuit breaker. Consult an electrician to select and
install this safety device;
• Do not use the equipment barefoot, in wet or very humid places, do not touch metal surfaces attached to the ground or grounded, such
as pipes, motors, gutters, fences, windows, doors, metal gates, etc, this increases the risk of electric shock;
• Before cleaning or performing maintenance, disconnect the machine from the electrical network;
• Do not make splices in the cord. If required, ask for a power cord replacement at the nearest Schulz Authorized Dealer (The costs of
power cable replacement are the sole responsibility of the customer).
• Power outlet must be compatible to the tool plug. To reduce the risk of shock, do not change the plug characteristics and do not use
adapters. If required, replace the outlet with a plug suitable model.
• Do not use your electric equipment in explosive atmospheres (gas, fl ammable liquid or dust). The motor generate sparks that may
cause explosion;
• Make sure the power trigger is in the "off" position before connecting the equipment to the power grid.
9. Maintenance / Operation:
10. Do not allow the compressor to come in contact with any flammable substances;
11. Never clean the compressor with solvents or any other flammable substances, use a neutral detergent.
12. Only qualified personnel are authorized to service electrically powered devices. Before attempting maintenance, the following conditions
must be satisfied:
• Ensure that main power is off, machine is locked out, tagged for service and power cannot be restored during service operations.
• Ensure that valves are shut and the air circuit is at atmospheric pressure. De-pressurize the dryer.
• Warranty does not apply to any unit damaged by accident, modification, misuse, negligence or misapplication. Unauthorized alterations
will immediately void the warranty.
13. Remove all adjustment tools before turning your equipment on. A tool or part stuck in moving of the equipment may cause serious
injuries;
14. In case of fire, use an approved fire extinguisher, water is not an acceptable means in cases of electrical fire.
15. In presence of any equipment abnormally, suspend its operation immediately and contact the nearest SCHULZ AUTHORIZED DEALER.
55
Tabla de contenido
loading

Tabla de contenido