MASTER/SLAVE MODE
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED Bar 324/10 RGB you can find an XLR-jack and an XLR-plug, which can be
used for connecting several devices.
This device then works as master-device and controls the slave-devices, which are to be connected to the
master-device via a stereo shielded cable. Connect the OUT-jack with the IN-plug of the next device.
SOUND CONTROL MODE
Press the MODE button and choose Sensitivity Mode. Select the desired input level (0 – 31) via the UP or
DOWN buttons
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder with a fitting screwdriver from the housing (anti-clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
22/43
00030054.DOC, Version 1.1