Pentair UltraTemp-E Serie Guia De Instalacion página 10

Relay Remote Controls
Note: Heat pump control board set points will be disabled and shown as N/A. Temperature Setup is done using an
external thermostat controlled system.
To connect remote control equipment to the heat pump, perform the following steps:
Note: Do not apply voltage to the Spa/Pool /Com terminals. A dry contact is required !
Connecting the Heat Pump to IntelliPool automation systems via the RS-485 Connector
Note: Heat pump control board set points will be disabled and shown as N/A. Temperature Setup is done within the
IntelliPool system (setpoint menu). The heater can be activated in the Command Menu on internet or the
settings/temp menu on the control center.
Note: Do not apply voltage to the RS485 terminals