Idiomas disponibles
Idiomas disponibles
3. If using a four-sided room, proceed to step 4.
a. If mounting roof beam towards the wall, utilize
the included beam bracket. (See Figures 11-12)
Roof Beam
Figure 12
Beam
4. Remove post caps from each post. This ensures that
the roof panels sit flush.
5. Set roof planels in place.
a. Use carriage bolts when attaching roof panel to
top of mounted wall panels. (See Figure 13)
PAGE 4 OF 12
INSTALLATION CONTINUED
Beam Bracket
Figure 11
Wall Bracket
Wall
Beam Bracket
Figure 13
b. Use hex bolts when securing roof panels together.
(See Figure 14)
Figure 14
NOTE: Hand-tighten all bolts until roof is fully
assembled. Fully tighten all bolts.
MOUNTING THE POSTS
1. Verify that all posts and panels are aligned evenly
and room is in desired location. Mark the floor where
the holes will be drilled.
2. Using a 3/8" masonry drill bit, drill a hole approximately
3" deep into the floor. (See Figure 15)
3. Clean out debris and dust from inside the hole, and
fully insert anchor bolt through the mounting plate
and into the hole.
4. Tap down the anchor bolt with a hammer. Slide
washer onto anchor bolt. Using a 17 mm wrench,
tighten the hex nut until the anchor bolt is secure.
Repeat for remaining anchor.
5. Repeat steps 1-4 for remaining posts.
Figure 15
Anchor Bolt
1-800-295-5510
uline.com
3/8"
Masonry
Bit
0523 IH-8305
