Idiomas disponibles
Idiomas disponibles
GB
Operation instructions BOB 190
Technical information
Case material: aluminum alloy
Size: Ø16 x 144mm
Weight: 42g (without batteries)
Batteries: 2 x AAA alkaline or rechargeable 1,5V
Light source: LED
Max. output: 190 lumens
Max. beam distance: 35 meters
Dustproof and waterproof grade: IP44
1 . installing the Batteries
Hold the aluminum casing firmly in one hand and turn the end cap in a
counter-clockwise direction until fully unscrewed (see Figure 1 ). Pull the
end cap away from the casing. Place each battery in turn, ensuring that the
polarity marks (+ and -) match. With all batteries installed turn the end cap
in a clockwise direction until fully tightened. The flashlight is now ready to
be used.
IMPORTANT
Please ensure that the batteries are installed correctly otherwise battery
damage may occur, possibly resulting in an explosion. Always change all the
batteries at the same time and only use high-quality ones of the same type
and brand. If you do not intend to use the flashlight for a long period
of time, remove the batteries to prevent them from leaking and damaging the
flashlight.
2. Operating the Flashlight
To switch on the flashlight simply press the end cap switch until the front or top light engages,
then release. To switch the flashlight off, press the end cap switch once again
until it disengages, then release it.
3. Optical focus in the top: Wide to narrow beam–sliding
MULTI BOB 190
MANUAL
1
