Idiomas disponibles
Idiomas disponibles
WORKING HINTS FOR YOUR PALM SANDER
Always use sand paper that is suitable for the material you want to sand. Always ensure the work-
piece is firmly held or clamped to prevent movement. Any movement of the material may affect
the quality of the sanding finish. Start your sander before sanding and turn it off only after you
stop sanding. For the best results, sand wood in the direction of the grain. Do not start sanding
without having the sandpaper fitted. Do not allow the sandpaper to wear away it will damage the
base-plate. The guarantee also cover base-plate wear and tear. Use coarse grit paper to sand
rough surfaces, medium grit for smooth surfaces and fine grit for the final surfaces. If necessary,
first make a test run on scrap material. Use only good quality sandpaper. The sandpaper controls
the sanding efficiency, not the amount of force you apply to the tool. Excessive force will reduce
the sanding fficiency and cause motor overload. Replacing the sandpaper regularly will maintain
optimum sanding efficiency.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. There are no user serviceable
parts in your power tool. Never use water or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage your power tool. If the supply cord
is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
TROUBLESHOOTING
1.If your sander will not operate, check the power at the mains plug.
2.If the sander does not abrade surface, check the sand paper. If the sand paper have been
worn, replace the new paper and try again. The paper must be kept in a dry place; If it is allowed
to become damp, the abrasive particles will lose their adhesion to the backing paper and will
not abrade.
3.If the sander dose not move smoothly, The sand paper may be loose, damaged or wrinkled.
Replace and try again.
4.If a fault can not be rectified return the sander to an authorized dealer for repair.
Page 11
