Idiomas disponibles
Idiomas disponibles
5.
Connect the power cord to the power source and then switch
on the vacuum cleaner by pressing the switch (10, fig. A).
EN
6.
To adjust the airflow, move the slider on the handle (1, fig.
A) up or down as preferred (fig. 10).
HEPA FILTER CLEANING FUNCTION
When using this function, the vacuum cleaner should remain
switched on and the flexible hose inserted into the body of the
device. Using the adjustable airflow handle, press the button on
the back of the top lid (fig. 11) and clean the filter.
Note! This function can only be used if the HEPA filter is slightly
dirty. After prolonged use of the device, the filter should be cleaned
(see: Cleaning and maintenance) or replaced.
VACUUMING UP LIQUIDS AND WET FLOORS
1.
To use the vacuum cleaner to clean spills and leaks, place the
sponge filter on the filter support (fig. 7).
2.
Connect the power cord to the power source and then switch
on the vacuum cleaner by pressing the switch (10, fig. A).
WASHING OF UPHOLSTERY AND CARPETS
1.
Place the sponge filter on the filter support (fig. 7).
2.
Place the nozzle of your choice on the telescopic tube - the
upholstery cleaning nozzle (22, fig. A) or the carpet and rug
cleaning nozzle (21, fig. A).
3.
Clean/wash the upholstery, carpet or rug using the appropriate
detergents as recommended by the manufacturer of the
surface to be cleaned.
4.
Connect the power cord to the power source and then switch
on the vacuum cleaner by pressing the switch (10, fig. A).
5.
Suck up residual water and detergent from the surfaces to
be cleaned. Repeat if necessary.
Note! If the tank overflows or the device overturns with
water inside, the device must be switched off immediately
and disconnected from the power source due to the risk of
damaging the motor. Overfilling of the tank will be signalled by
the characteristic sound of a clogged passage combined with
a drop in the device's suction power.
