Operation; Primary Filter Shaker; Emergency Stopping - Blastrac BDC-133M Manual De Instrucciones

Operating manual BDC-133M / BDC-133H

Operation

The air speed in the suction tube must not be less
than 20 m/s.
This state is shown by the green indicator of the
primary filter.
When using the vacuum cleaner, check:
■ the state of the max. vacuumed material level indicator
(7 - Fig. 5) if the level check is installed.
■ The state of the primary filter (9 - Fig. 5) and the
absolute filter (if installed) (10 - Fig. 5).
■ The state of the low compressor pressure indicator (6 -
Fig. 5) (if installed).
If one of the indicators is lit, follow the instructions.
Indicator
Symbol
signal
Low compressor
pressure
(6 - Fig. 5)
bar/psi
MAX
Max. vacuumed
material level
(7 - Fig. 5)
bar/psi
X
Primary filter
(9 - Fig. 5)
Absolute filter
GB
(class H
models)
(10 - Fig. 5)
Class H vacuum cleaners can be used only
with hoses whose diameters comply with the
specifications in the Technical data table.
Consult the "Troubleshooting" chapter if faults
occur.
WARNING!
WARNING!
Vacuum cleaner
Indicator
colour
Suction stopped.
MAX
Red compressor is
functioning properly
Suction stopped.
Empty the container
Red
Use the primary
filter shaker after
Red
vacuum cleaner
(on models with
a manual filter
Change absolute
Red
WARNING!
WARNING!

Primary filter shaker

Manual primary filter shaker
In relation to the quantity of material vacuumed and if
indicator (9 - Fig. 5) is red, turn the vacuum cleaner off and
use knob (1 - Fig. 9) of the manual filter shaker.
Stop the vacuum cleaner before using the filter
shaker.
Do not shake the filter while the vacuum cleaner is
on, as this could damage the filter.
Wait before restarting the vacuum cleaner, to allow the dust
to settle. Replace the filter element if the indicator remains
red (9 - Fig. 5) even after the filter has been shaken (consult
the "Primary filter replacement" paragraph).

Emergency stopping

state and
Press Stop button (5 - Fig. 5). The vacuum cleaner stops.
procedure
Check the
The motors and internal components of the vacuum
cleaner will still be electrically powered.
(if installed).
To start the vacuum cleaner again, press the buttons of each
single motor or turn main switch(1 - Fig. 5) to "0" and then
to "I" again.
(see relevant
paragraph).
Suction on.
stopping the
shaker).
Suction on.
filter
(see relevant
paragraph).
Figure 9
WARNING!
WARNING!
www.blastrac.eu ‒ [email protected]
8/18