Idiomas disponibles
Idiomas disponibles
7.6 Timer operation
Timer ON setting:
– When the air-conditioner is OFF, press the "Timer" button and select a desired ON time
through the temperature and time setting buttons.
– "Preset ON Time" is displayed on the operation panel.
– ON time can be regulated at any time in 0-24 hours.
Timer OFF setting
– When the air-conditioner ON, press "Timer" button and select a desired OFF time
through the temperature and time setting buttons.
– "Preset OFF Time" is displayed on the operation panel.
– OFF time can be regulated at any time in 0-24 hours.
7.7 Auto SWING
After machine turns on, press this key, the louver will swing continuously left and right;
by pressing this button again the movement will stop and the louver remain in that
position.
7.8 SLEEP mode
– While in cooling mode, press the SLEEP key to set the temperature. It increases1ºC
after an hour and at most increases 2ºC after 2 hours.
– While in heating mode, press the SLEEP key to set the temperature. It decreases 1ºC
after an hour and at most decreases 2ºC after 2 hours.
– Press the SLEEP key again can cancel the setting.
7.9 Water drainage
Water Full Alarm
The inner water tray in the air-conditioner has one water level safety switches, it controls
the water level. When water level reaches an anticipated height, the water full indicator
lights up. When the water is full, please remove the rubber blockage from the drainage
outlet at the bottom of unit and drain all water outside.
CONTINUOUS DRAINAGE
– When you plan to leave this unit unused for a long time, please remove the rubber
blockage from the drainage hole at the bottom of unit and drain all water outside.
– You can use the continuous drainage with a drainage hose connected to the bottom
drain hole, when the unit working at the HEAT mode.
– The continuous drainage does not need to be applied when the unit working at the COOL
or DEHUMIDIFY mode. The unit can evaporate the condensate water automatically by the
splash motor. Make sure the drainage holes are stemmed well.
– If water splash motor is damaged, continuous drainage can be used. To connect the
drain hose to the bottom drainage outlet (Fig.6), the unit can also work well.
– If splash motor is damaged, intermittent drainage can also be used. Under this condition,
when the water full indicator lights up, please connect a drain hose to the bottom drainage
• •
1
28
