BTI PROFILINE A-UM 10,8V LI Manual Original página 36

OBJ_BUCH-891-001.book Page 36 Wednesday, January 21, 2009 3:34 PM
Temperature Dependent Overload Protection
When using as intended for, the machine cannot be
overloaded. In case of excessive loading or when
exceeding the allowable battery temperature range of
0–70 °C, the speed is reduced or the machine
switches off. In case of reduced speed, the machine
will not run at full speed until after reaching the allow-
able battery temperature again. In case of automatic
shut-off, switch the machine off, allow the battery to
cool down and then switch the machine on again.
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between 0 °C and 45 °C. As an example, do not leave
the battery in the car in summer.
A significantly reduced working period after charging
indicates that the battery is used and must be replaced.
Observe the notes for disposal.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself (e.g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the bat-
tery from the power tool. There is danger of
injury when unintentionally actuating the On/Off
switch.
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean Riff application tools (accessory) regularly with
a wire brush.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for BTI
power tools.
In all correspondence and spare parts orders, please
always include the 7-digit order number given on the
nameplate of the machine.
36 | English
Transport
The battery is tested according to UN document
ST/SG/AC.10/11/Rev.3 Part III, subsection 38.3. It
has effective protection against internal overpressure
and short circuiting as well as devices for the preven-
tion of violent rupture and dangerous reverse current
flow.
The lithium-equivalent content in the battery is below
applicable limit values. Therefore, the battery is not
subject to national or international regulations pertain-
ing to dangerous mediums, neither as an individual
component nor when inserted into a machine. How-
ever, the regulations governing dangerous goods may
be relevant when transporting several batteries. In this
case, it can be necessary to comply with special con-
ditions (e.g., concerning the packaging).
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must be collected sep-
arately and disposed of in an environmentally correct
manner.
Battery packs/batteries:
Li-ion:
Please observe the instructions in
section "Transport", page 36.
Do not dispose of battery packs/batteries into house-
hold waste, fire or water. Battery packs/batteries
should be collected, recycled or disposed of in an
environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 91/157/EEC.
Subject to change without notice.
1 609 929 S48 • 21.1.09