Idiomas disponibles
Idiomas disponibles
Rotary hammer
Before start
WARNING! Always remove the battery from
the rotary hammer before starting any work
with the rotatry hammer.
Fitting and changing tools (Fig. 1)
The device is equipped with a SDS plus attachment system.
• Clean tools and grease with a thin layer of machine grease
before fitting.
• For assembly, pull back fastening sleeve and hold. Push
and rotate the dust-free tool into the tool holder as far as it
will go. The tool will lock automatically. Check that it has
locked by pulling the tool.
• To remove SDS-plus tool, pull back fastening sleeve and
remove tool.
Warning: Accessories can be hot after use. Don't touch the
tip of drill bit by hand! Always use protective gloves to
remove the accessory!
Fig. 1
Depth guide (Fig. 2)
Your drilling depth can be pre-set and/or repeated by using
the depth stop.
Insert the required drill bit. Fit the depth stop into the hole
of auxiliary handle and set the required depth.
Fig. 2
Fitting the auxiliary handle (Fig. 3)
Warning: Always use the tool with the auxiliary handle
properly assembly .
Loosen the auxiliary handle by unscrewing it. Slide the
auxiliary handle clamp over the collar behind the bit holder.
Rotate the side handle to the desire position and tighten
the handle.
INSTRUCTION MANUAL
EN
Fig. 3
Selecting the operation mode (Fig. 4)
The rotary hammer drill can be used in the following
operation modes:
Rotary drilling - For screwdriver and for drilling
into steel, wood and plastics.
Hammer drilling - Simultaneous rotating and
impacting for concrete and masonry drilling.
Hammer only - For light chipping, chiselling and
demolition applications.
Bit rotation - Non-working position used only to
rotate a flat chisel into the desire position.
Select the required operating mode by depressing the
safety button (a) and rotating the mode selector switch until
it points to the symbol of the required mode.
Release the safety button and check that the mode selector
switch is locked place.
Fig. 4
Do not select the operating mode when the tool is running.
Warning: Always wait until the machine has come to a
complete
standstill
before
hammer/drilling function.
Warnging: Do not use the chuck with SDS connector in
combination with the hammer/hammer drill function!
REF. 08763
a
changing
the
drilling
,
