Idiomas disponibles
Idiomas disponibles
Installation
PROCEDURE C
1
Redirect the louvers at the back of the wall
sleeve to 60° angle as shown in Figure 14.
The use of pliers is recommended.
60°
Rear Louvers
(Top View)
2
If the wall sleeve already has a rear grille, skip
to step 4. If the wall sleeve does not have a rear
grille or louvered panel, install the plastic grille
from the kit. Cut the plastic grille to 26-1/2" wide
and 15-1/2" high. Place the plastic grille to the
inside of the wall sleeve at the rear flange.
Place the plastic grille
3
Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes of
the rear flanges.
Fasten the screws
16 Room Air Conditioner
7
"
3 /
32
60°
Figue 14
Figure 15
or
Figure 16
4
Remove the backing from the horizontal
insulation strip 23
that to the inside right of the sleeve as shown
below. Remove the backing from the around
insulation strip 59
that to the inside front of the sleeve as shown
below.
Around Insulation
Horizontal Insulation
If the depth of your existing sleeve is less than
5
or equal to 18", skip to step 7. Otherwise, cut
the baffles and the support blocks according to
Length A in the table below.
Depth D of the existing
wall sleeve (inches)
18 D 18-
/
5
8
18-
/
D 19-
/
5
3
8
4
19-
/
D 22
3
4
Remove the backing from the support blocks
6
and attach them to the inside of the wall sleeve
as shown in Figure 19. Slide the baffle into slots
of the support blocks
Wall
Wall
Sleeve
Front
x 1
x 1
and attach
7 /
3 /
3 /
32
8
16
x 1
x 1
and attach
27 /
3 /
3 /
32
8
8
Indoor
Outdoor
8
/
"
1
2
Figure 17
A
Length A
(inches)
Support
Block
/
3
4
1-
/
3
Baffle
4
4
A
Figure 18
(
7
3 /
32
Baffle
Support
Block
Figure 19
)
"
