Idiomas disponibles
Idiomas disponibles
EN
1. product description
CALAF series Inverter MIG/MMA Welder are designed to be used with the advanced IGBT (Insulated Gate Bipolar Tube) and
rapid recovery diode as its main control and transfer components and assisted with the specially developed control circuit. It is
available to MIG ( both CO2 gas-shielded welding and flux-cored welding) and MMA welding. It uses arc between wire and work
piece as heat source to melt wire and master material metal, and then sends shielded gas to welding site, which makes the melt
pond and master material metal free from around air's erosion. The continuous wire can form welding seam metal after melting so
as to connect the wok pieces each other. The melting electrode gas protects the welding district easily, so it is easy to operate &
observe the whole working process. Its characteristics are high produce efficiency and easy to carry out all-position welding. The
machine is light and portable which is very popular in DIY and semi-professional market.
The highlighted characteristics of CALAF Series Inverter MIG/MMA Welder:
• Featured with small volume and light weight, it widely used in upholstering field, repairing field and fieldwork.
• By various sound protection performance, it can keep the welding machine from overheating, over voltage, under voltage, over
current and so on. When the main supply compensation is not less than ±15%, it can increase while the welding current reduces.
Because of its anti jamming high performance, the control system can respond to the power source, work piece, electrode and
operational changes with less than 1m/s speed in order to keep steady output of the current.
• High working efficiency. Automatic Wire Feeding can realize high speed welding.
• No special requirements for the welding wire. Both solid and flux-cored wires are available. The diameter of the wire is between
0.6~0.8.
• Convenient connection mode. outer connection make it quick, safe, simple and reliable.
• Undercutfunction make arc-piloting more successful.
• MMA function is also available. And it also can weld cellulosic electrode.
2. SAFETY
2.1 SELF-PROTECTION
• Please always follow the rules that conform to safety and hygiene. Wear protective garments to avoid injuries to eyes and skins.
• Use the welding helmet to cover your head while working with the welding machine. Only viewing through the filter lens on the
welding helmet can you watch your operation.
• Prevent the sparks and spatter from harming your body.
• Under no circumstance can you allow any part of your body to touch the welder's output bipolarity.
• Do not operate under water or more humid place.
• Fumes and gases produced when welding are hazardous to health. Make sure to work in places where there are exhaust or
ventilation facilities to keep fumes or emissions away from the breathing zone.
2.2 attentION
• CALAF series Inverter MIG Welder are electronic products whose spare parts are very tender, do not change or adjust with a
rush otherwise the switch will be damaged.
• Check the connection to see if it is well connected, whether the grounding connection is reliable, etc.
• Please remember to keep arc rays away from the other nearby people when welding. This is only due to the interference from
arc rays.
3
