Strimmer Wire; Recommended Strimmer Wire Diameters; Fitting The Strimmer Wire - pellenc EXCELION ALPHA Manual De Instrucciones

4. Position the supplied Torx 25 spanner or a Torx 20
screwdriver in the slot between the cutting head (8)
and the motor (21).
5. Turn the cutting head until you find the notch to block
the rotation of the cutting head support (8).
6. Insert the supplied Torx 25 spanner or the head of
a screwdriver into the notch of the cutting head sup-
port (25) to lock the rotation.
7. Tighten by screwing the cutting head counterclock-
wise onto the motor shaft.
8. Remove the screwdriver.
9. Remount the protective casing (see Section 4.2.1,
"Fitting the protective guard").

6.5. STRIMMER WIRE

6.5.1. RECOMMENDED STRIMMER WIRE DIAMETERS

Vegetation type
Border / Lawn / Grass
Dense and tall grass

6.5.2. FITTING THE STRIMMER WIRE

Caution
Always disconnect the battery before performing maintenance on the cutting head.
1. Position the arrows on the wire spool (23) opposite
the arrow on the TAPCUT 2 cover (24).
74
GRASS STRIMMER EXCELION ALPHA
53_144013_C
Ø PELLENC strimmer wire
2.4 mm
3 mm