Disposal And Recycling - EINHELL Expert TE-TC 620 U Manual De Instrucciones

•
Install the new cutting wheel in reverse order
and tighten.
•
Important: Pay attention to the direction of
rotation of the cutting wheel!
8. Maintenance
•
Remove dust and dirt from the machine at
regular intervals. Cleaning is best carried out
with a rag or brush.
•
Lubricate all moving parts at regular intervals.
•
Never use caustic agents to clean plastic
parts.
•
The trough (3) and the cooling water pump
(13) must be cleaned at regular intervals or
proper cooling of the diamond cutting wheel
(2) will not be guaranteed.
8.1 Transport (Fig. 17)
•
If you want to move the equipment to a
different location, first undo the clamping
screws (12) and push them together with the
machine head (29) to the same side as the
transport wheels (19), then fasten the two
clamping screws (12) again.
•
Fold up the feet (1) one after the other, star-
ting ideally on the same side as the transport
wheels (19) in order not to overload the trans-
port handle (18) when putting the equipment
down.
•
You can now transport the equipment by the
transport handle (18).
•
You can park the equipment in minimum
space as shown. When doing so, put your
foot on the axle to prevent the equipment
rolling away.
Anl_TE_TC_620_U_SPK8.indb 30 Anl_TE_TC_620_U_SPK8.indb 30
GB

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.
10. Storage
Store the equipment and its accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
- 30 -
08.11.12 12:50 08.11.12 12:50