Idiomas disponibles
Idiomas disponibles
EN
4
9
OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
9.1
START THE MACHINE
Always avoid over-inflation and never leave the
inflator unattended when in use.
1.
Press the On/Off button (11).
2.
Push the mode selection button (12) to choose
high pressure or low pressure mode.
3.
The digital pressure gauge (13) will display the
current pressure (in 1 PSI increments) of the item
you are inflating on the upper section of the LCD
Screen.
4.
Press button (14) to increase PSI, or press button
(15) to decrease PSI.
5.
To start the inflator, push the run/pause button
(16).
6.
To change the target PSI level, push the Run/
Pause button (16) again and the adjust level.
7.
To stop the inflator before it reaches the target
PSI level, push the run/pause button (16). To
resume inflation, simply press the button again.
Press the On/Off button (11) to turn the inflator
off. The power automatically cycles off after five
minutes of no activity.
17
16
11
3
WARNING
WARNING
WARNING
14
15
12
English
• When you work under dim ambient, press the LED
light button (17) to turn on the light.
• When the LCD readout screen is displaying the
target PSI, the LCD readout will flash 3 times at
the desired preset level.
• The pressure value of the low pressure mode is
fixed and cannot be adjusted.
• The inflator will shut off automatically at
the desired target PSI level that you have
programmed into the target PSI setting.
• The inflator has a tolerance of -5 PSI and will
automatically shut off accordingly.
• If the current pressure of the item you are inflating
is greater than the target PSI, the inflator will not
turn on.
10
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Do not use strong solvents or detergents on the
plastic housing or components.
10.1
CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks
of electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
8
NOTE
WARNING
WARNING
CAUTION
