Features - Foy TBA310 Manual De Usuario

damage to the battery pack, burns or a fire. If
storing or disposing the battery pack, cover the
terminals with a heavy insulation tape to en-
sure short circuit cannot occur. Batteries, when
stored for a long period of time, will discharge.
• Do not store or use the tool and battery pack
in locations where the temperature may reach
or exceed 50°C such as alongside sheds or met-
al structures in the summer.
• Allow the battery pack to cool down after
charging. Do not place it in a hot environment
such as a metal shed or open trailer left in the
sun.
• Only charge the battery with the charger sup-
plied.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
2
1
6
3
1. KEYLESS CHUCK
2. TORQUE SELECTOR
3. ON/OFF/VARIABLE SPEED SWITCH
4. FORWARD/REVERSE CONTROL
5. LED WORKLIGHT
6. BATTERY PACK
7. CHARGER
CHARGING BATTERY
1. Attach the battery pack
to the charger by aligning
the raised portion of the
battery pack with the slot in
the charger. Slide the battery
pack onto the charger.
2. The charger will communicate with the bat-
tery pack's circuitry to evaluate the condition
of the battery pack.
3. The POWER BAR LED lights will lit circularly
from right to left and the green LED indicator
will be flashing during charging. This is part of
the normal charging operation.
4. After charging is complete, the green LED on
the charger will come ON and the POWER BAR
LED lights will go OFF. The POWER BAR LED
lights will not be displayed when the POWER
BAR BUTTON is pressed while the battery pack
is on the charger.
5. The battery pack will fully charge, but will
not overcharge, if left on the charger.
NOTE: During the charging procedure, the bat-
tery warms up, this is normal.
INSERTING AND REMOVING A BIT
WARNING: Remove the battery pack and set
the forward/reverse control to the locked cen-
ter position when installing or removing bits to
prevent accidental starting.
TO INSTALL
Turn the keyless chuck
clockwise direction to
loosen the collet, insert
the bit or other accesso-
ry into the keyless chuck
4
and tighten
by turning the keyless
chuck counter-clockwise
5
direction.
Make sure the keyless chuck is tightened in
place.
TO REMOVE
To remove the bit or accessory, turn the keyless
chuck clockwise direction to loosen the collet,
and then get the bit out.
FORWARD/REVERSE CONTROL
The forward/reverse control determines the di-
rection of rotation of the tool.
To select forward rota-
tion, release the trigger
switch and push the for-
ward/reverse control to
the left side of the tool.
To select reverse, push
the forward/reverse con-
trol to the right side of
E N G L I S H •
Tighten
securely
Loosen
U ser's m anual
13