Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS for the installer and the user
Read these instructions carefully before starting any assembly operation.
1 - All the installation and maintenance operations must be carried out by qualified
personnel.
2 - The manufacturer declines all responsibility in the event of assembly which does
not respect these instructions, or the use of non original material or accessories.
3 - Always install the towel warmer heater as specified in these instructions
BEFORE connecting the appliance to the mains power supply.
4 - If the cable become damaged it must be replaced by the manufacturer, by the
authorised assistance service or by a technically qualified person in order to avoid
all risks.
5 - The heating appliance must not be placed under an electric socket but in such
a position that the switches and other control devices cannot be touched by a per-
son who is in the bath tub or under the shower.
6 - Avoid using the radiator in the presence of gas, explosives or inflammable prod-
ucts.
7 - Contact the manufacturer immediately if 4 of the 8 temperature indication leds
are flashing, as this means that the temperature probe is broken.
ELECTRICAL CONNECTION
Cables: grey (or blue) = neutral, brown = phase, black
Power supply for single-phase current 230V ~ 50 Hz.
The connection must be made in compliance with the regulations in force; before
connecting the electric resistance to the line, check the voltage and power values
indicated on the data plate.
FITTING THE DEVICE
1 - The device must be fitted to the radiator /napkin heater as shown in figure 2
2 - During mixed operation, the radiator tap must be turned off and the holder valve
open.
3 - The radiator to which the device is fitted may be installed in zones 2 and 3 only
(see fig. 1).
