Time Mode; Temperature Measurement; Change Of Temperature Unit - SKF TIH 030m Instrucciones De Uso

• Press START/STOP to start the heater. The remote control display shows the
current temperature of the workpiece.
• During heating the selected temperature can be displayed for 1 second by
pressing MODE.
• When the selected temperature has been reached, the heater demagnetises
the workpiece, switches off, and generates an acoustic signal for 10 seconds or
until START/STOP is pressed.
• Press START/STOP to stop the heater.
• Remove the workpiece with proper handling equipment.
• If the workpiece remains on the heater, the heater will start again when the
temperature of the workpiece drops 10 °C (18 °F). Press START/STOP to stop
the heater and demagnetise the workpiece.
• The TIH 030m is now ready to heat another workpiece with the same settings.
5.4

TIME MODE

• If the remote control display shows °C or °F, press MODE to select TIME MODE.
The remote control display shows 't' in TIME MODE.
• Press UP or DOWN to adjust the time in steps of 0.1 minute.
• Press POWER to select the power level. Use the guidelines in section 5.8 to
determine the correct power setting.
• Press START/STOP to start the heater. The remote control display shows the
time that remains.
• During heating the temperature measured by the probe can be displayed for a
couple of seconds by pressing MODE.
• When the time has elapsed, the heater demagnetises the workpiece, switches
off, and generates an acoustic signal for 10 seconds.
• Press START/STOP to cancel the acoustic signal and stop the heater.
• Remove the workpiece with proper handling equipment.
• The TIH 030m is now ready to heat another workpiece with the same settings.
5.5

Temperature measurement

When the heater is not operating, the temperature of the workpiece can be
measured by pressing MODE and START/STOP at the same time. The LED on the
START/STOP button flashes during temperature measurement.
Press START/STOP to cancel temperature measurement.
5.6

Change of temperature unit

Press MODE and UP at the same time to switch between °C and °F.
The temperature unit setting remains the same even after disconnection from
mains power.
12 SKF TIH 030m