Parts
Non-skid
TRUPER
Vibration Control
handle
Ventilation
slots
Switch
Auxiliary
handle
Aluminum
head
Retaining
lever
Cable
protector
Power
cord
Tool holder
Assembly
CAUTION
To prevent accidents, confirm that the switch is off and
disconnect the plug from the power supply.
WARNING
Wear gloves whenever you change accessories.
They can become extremely hot during the operation.
A
• Clean the accessories shanks and apply grease from the included tubes
before mounting them on the tool fastener (A).
• The attachments are secured in the tool chuck by the retaining lever (B).
The position of the lever depends on the type of shank of the fixture being
B
used, usually slotted or shouldered.
SLOTTED ACCESSORIES (C)
• Move the retention lever to the bottom of the fastener without reaching
the tool axis, as shown in the image (D).
• Insert the accessory into the fastener; ensure that the attachment slot is
C
D
parallel to the retention lever.
• Return the lever to its original position to lock the attachment (E).
• Pull the bit to confirm that it is fully secured.
• To remove the accessory, move the lever to the tip
of the drill chuck and remove the accessory.
E
6
ENGLISH
