LG WM3477HS Guía Del Usuario E Instrucciones De Instalacion página 25

H O W TO U S E
SPECIAL FUNCTIONS
The option buttons also activate special
functions, including Child Lock and Tub Clean.
Press and hold the option button marked with the
special function for 3 seconds to activate.
Child Lock
operating. Press and hold the Beeper On/Off button
for 3 seconds to activate or deactivate Child Lock.
The lock icon will be shown in the display, and all
controls are disabled. The washer can be locked
during a cycle. Once Child Lock is selected, the
display will alternate between CL and the remaining
time.
Tub Clean
designed to remove this buildup. Add anti-
limescale agent (Calgon) to the main wash
compartment.
Press and hold the Water Plus button for 3
seconds to activate this cycle.
After the cycle has ended, open the door and
allow the drum interior to dry completely.
Refer to Care and Cleaning of the Interior for
further information.
NOTE: Do NOT use this cycle with clothes,
and do NOT add detergent or fabric softener.
NOTE: If you use the Tub Clean cycle on a
monthly basis, the wash drum will be kept clean.
24
Use this option to prevent
unwanted use of the washer or
to keep cycle settings from being
changed while the washer is
A buildup of detergent residue
can occur in the wash tub over
time and can lead to a mildewy
or musty smell.
The Tub Clean cycle is specially
Hand Wash/Wool
• Only woolen items that are designated as
Machine-Washable should be washed in this
washing machine
• Wash only small loads for optimum fabric care
(less than 8 lbs.)
• Only neutral (wool safe) detergents should
be used (Only a small quantity of detergent
is needed due to the small load size and low
volume of water in the cycle.)
• The Hand Wash/Wool cycle uses a gentle
tumble action and low speed spin for ultimate
fabric care
Tub Clean Alarm
Counts once after a Full Cycle is complete (Wash,
rinse, and spin cycles)
Check the cumulative count when powered on,
and if over 30, display "
display for 5 seconds.
Start flashing " " after 5 seconds (0.5 sec
On, 0.5 sec Off), and display "---" or "time"
depending on the water detection setting of the
selected course.
(※ Continuously display "Proceed with Tub Clean"
on LCD models)
TCL does not count during Life or LQC modes.
Clear " ": Select button or rotate the dial to
select general administration.
Cumulative Count Reset
• Cumulative count resets to zero when the Tub
Clean course is complete.
• Cumulative count resets to zero after displaying
" " once. (Resets after 31 TCL counts)
• Resets after a Full Cycle in LQC mode.
Cumulative count is displayed on the LED for TCL
count according to the data key.
" on the 7-segment