Idiomas disponibles
Idiomas disponibles
CP FL 0022, CP FL 0022 S
WARNING
Ejected insertion tool
If the tool retainer on the machine is not in a locked
position, the inserted tool can be ejected with force,
which can cause personal injury.
Never start the machine while changing the
►
insertion tool.
Before changing the insertion tool or accessories,
►
stop the machine, switch off the power supply
and bleed the machine by activating the start and
stop device.
Never point the inserted tool at yourself or anyone
►
else.
Make sure that the insertion tool is fully inserted
►
and the tool retainer is in a locked position before
the machine is started.
Check the locking function by pulling the inserted
►
tool outwards forcefully.
WARNING
Moving or slipping insertion
tool
An incorrect dimension of the inserted tool s shank
can result in that the inserted tool is lost or is slipping
out during operation. Risk of severe injury or crushed
hands and fingers.
►
Check that the insertion tool has the shank length
and dimensions that the machine is intended for.
Never use an insertion tool without a collar.
►
Operation, precautions
DANGER
Explosion hazard
If an insertion tool comes into contact with
explosives or explosive gases, an explosion could
occur. When working on certain materials and when
using certain materials in machine parts, sparks and
ignition can occur. Explosions will lead to severe
injuries or death.
Never operate the machine in any explosive
►
environment.
►
Never use the machine near flammable materials,
fumes or dust.
Make sure that there are no undetected sources
►
of gas or explosives.
9800 0836 90a | Original instructions
Safety and operating instructions
WARNING
Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or slipping
may cause injury.
►
Make sure that you always keep a stable position
with your feet as far apart as your shoulder width,
and keeping a balanced body weight.
Always inspect the equipment prior to use. Never
►
use the equipment if you suspect that it is
damaged.
Make sure that the handles are clean and free of
►
grease and oil.
►
Keep your feet away from the inserted tool.
Stand firmly and always hold on to the machine
►
with both hands.
►
Never start the machine when it is lying on the
ground.
Never 'ride on the machine with one leg over the
►
handle.
Never strike or abuse the equipment.
►
Check regularly for wear on the insertion tool,
►
and check whether there are any signs of damage
or visible cracks.
Pay attention and look at what you are doing.
►
7
