Idiomas disponibles
Idiomas disponibles
To stop the product
1. Move the ON/OFF switch to the OFF position (if
equipped).
2. Remove the ON/OFF key.
To use the throttle control
•
Turn the throttle control (A) to change the
amount of fuel used. Always operate the engine
at full throttle.
A
To use the fuel switch
•
Turn the fuel switch to open or close the fuel
valve. Operate the product with the fuel switch in
the OPEN position.
OFF
To use the choke control
•
Turn the choke (A) to open or close the choke
valve. Use the choke to start a cold engine.
A
To adjust the skid plates
No adjustment is required for normal installation.
791 - 002 - 08.01.2020
FUE
LCO NTR OL
INSTRU CTION S
ON
1. When the lock nut (B) is loose or the skid plate
(A) is not high enough from the ground, unlock
the lock nut (B) with a 13 mm open-ended
wrench, to move the skid plate up or down.
2. On flat surfaces, like asphalt roads, raise the skid
plates (A) 5-6 mm (0.2-0.25 in) off the ground.
On uneven surfaces, like gravel roads, make the
clearance between the ground and the product
larger with the skid plates to get the scraper bar
above the top of the gravel. Make sure that the
gravel and stones do not enter into the product. It
can cause personal injuries if objects are ejected
at high speed.
3. Tighten the lock nut (B).
To prevent freeze-up after use
Note: Controls and moving parts can be blocked by
ice. Do not apply much force to the controls. If you
cannot operate a control or a part, start the engine
and let it operate for some minutes.
1. Start the engine and let it operate for some
minutes. Stop the engine and wait for all moving
parts to stop.
2. Remove snow and loose ice from the product.
3. Remove snow and loose ice from the base of the
chute.
4. Turn the chute deflector to the left direction and
to the right direction to remove ice and water.
5. Remove the key or flip switch to the "OFF"
position (if equipped).
6. If the product does not have an electric starter,
pull the starter rope handle several times to
remove ice and water.
7. If the product has an electric starter, connect the
product to power and push the start button once
to remove ice and water.
To get a good result
•
Always run the engine at full throttle or near full
throttle.
•
Always adapt the speed of the product to the
snow situation and adjust the speed with the
drive speed control lever. Make sure that the
product throws snow evenly.
A
B
13
