Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE - Spout
3. Orient spout assembly as shown
and lower onto exposed portion
of diverter valve.
Push firmly until fully seated. Take
care not to damage the o-rings.
Use hex key to fasten spout to
valve with provided set screw.
Tighten as needed.
INSTALLATION PROCEDURE - Handles
1.
Orient handle assembly and lower
onto the exposed portion of valve until
engaged. Rotate the base (dome) of the
handle assembly to fasten it to the valve.
Repeat for other handle assembly.
NOTE: If handles do not line up exactly
as desired, remove handle from valve and
reinstall one (1) notch over (on valve).
SIDE VIEW
4
