Technical Data
Code
Description
Grinding Wheels
Voltage
Frequency
Current
Power
Speed
Duty cycle
Conductors
Insulation
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power Requirements
If faults or breakdowns happen. Ground connection offers a
WARNING
trajectory with minimum resistance for electric power. It reduces the risk of electric
shock. This tool is built with a power cable with an earth conductor and ground
connection. The plug shall be connected into a power outlet installed and grounded
according to all local codes.
CAUTION
When using an extension cord, verify the gauge is enough for the
power that your product needs. A lower gauge cable will cause voltage drop in the
line, resulting in power loss and overheating. The following table shows the right size to use depending on cord´s length and the
ampere capability shown in the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
WARNING
When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are specially designed for
operating outdoors and reduce the risk of electric shock.
50 minutes work per 20 minutes idle. Maximum 6 hours per day
18 AWG X 3 C with insulating temperature of 221 °F
Power Cord Grips used in this product: Type "Y"
Tool Build Quality: Basic Insulation
Thermal insulation on motor winding: Class B
Number of
Conductors
From 6 ft to 49 ft
3 (one grounded)
EBA-6
12785
Bench Grinder
6"
127 V
60 Hz
3 A
1/2 Hp
3 450 RPM
Class I
Authorized Service Center.
Extension Gauge
|
Higher than 49 ft
18 AWG
16 AWG
14 AWG
8 AWG
grounded
16 AWG
14 AWG
12 AWG
6 AWG
3
ENGLISH
