Tabla de contenido
ASSEMBLY
Make sure your fan is switched off before connecting to or disconnecting from power supply.
Ensure that the voltage rating on the base plate corresponds to the main-voltage at your
home.
Remove all packaging from the parts of the fan.
Warning! Never use the fan without the guard in place or if the guard is damaged.
Assembling the base and stand:
Remove the flat washer (14) and screw (15) from the support tube by turning it
anti-clockwise.
Place the support tube into the base. Re-insert the screw into the support tube from
underneath. Tighten the screw by turning it clockwise.
Fitting the fan to the stand
Remove the screw from the bottom of the fan unit by turning it anti-clockwise.
Place the fan unit onto the top of the support tube. Re-insert the screw into the fan unit.
Tighten the screw by turning it clockwise.
Fitting the fan blade and guard
Remove the guard nut from the motor shaft by turning it anti-clockwise.
Place the rear guard by positioning it on the location pins on the fan unit.(ensure that the
rear guard is in the correct orientation)
Tabla de contenido
