Idiomas disponibles
Idiomas disponibles
36
SPECIFICATIONS
Problem
Wrinkling
y Did you remove the load immediately after it
y Did you overload the tub?
y Did you reverse the hot and cold water inlets?
Power is not turned on
y Is the power cord plugged in properly?
y Has a house fuse blown, a circuit breaker
The door does not open
y Is the temperature in the tub too high?
when the cycle pauses or
y Is the water level in washer high?
finishes
The wash cycle time is
y Is the washing machine overloaded? Are other
longer than usual
It is musty or moldy in the
y Has the incorrect detergent been used?
tub
y Did you clean the tub periodically?
SPECIFICATIONS
Model WM2650HVA / WM2650HWA
Description
Front loading washing machine
Electrical requirements
120 V~, 60 Hz
Dimensions
686 mm(W)×756 mm(D)×983 mm(H) / 1295 mm (D, door open)
Net weight
83 kg (182 libras)
Wash capacity
16.0 kg (35 libras)
Max. Watt
1000 W
Max. spin speed
1200 rpm max.
Max. water pressure
0.3-10kgf/cm
Possible Causes
finished?
tripped, or a power outage occurred?
options added to the wash cycle?
(30-1000kPa)
2
Solutions
y Remove the load immediately after it finishes.
y Do not overload the tub.
y Hot water rinse can cause garments to
wrinkle. Check the inlet hose connections.
y Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
y Reset the circuit breaker or replace the fuse.
Do not increase the fuse capacity. If the
problem is a circuit overload, have it corrected
by a qualified electrician.
y The washing machine has a safety lock built
into the door to prevent burning. Leave the
door closed and wait until the door lock icon
disappears from the display.
y Allow the washer to complete the
programmed cycle, or Press the SPIN button.
y This is normal. The washing machine
automatically adjusts the cycle time for the
amount of laundry, water pressure, water
temperature, and other operating conditions.
y See page 30, clean the inside and outside of
the washing machine periodically.
