Idiomas disponibles
Idiomas disponibles
3. Raise the front of the drill slightly and insert the driver or
drill bit (Fig. 7).
NOTE: Drill bit is not included.
Fig. 7
Opening
Phillips
head
Slotted
head
Drill bit (not included)
m
WARNING!
Make sure to insert the driver bit/drill bit
straight into the chuck jaws. Do not insert the driver bit/drill bit
into the chuck jaws at an angle, then tighten. This could cause
the driver bit/drill bit to be thrown from the drill, resulting in
possible serious personal injury or damage to the chuck
(Fig. 8).
Fig. 8
Wrong/incorrect
4. Rotate the chuck sleeve clockwise to close and tighten
the chuck jaws (Fig. 9).
Fig. 9
Chuck jaws
Chuck sleeve
m
WARNING!
Do not hold the chuck sleeve with one hand
and use the power of the drill to tighten the chuck jaws on the
driver bit/drill bit. The chuck sleeve could slip in your hand,
or your hand could slip and come in contact with the rotating
driver bit/drill bit. This could cause an accident resulting in
serious personal injury.
5. To remove bits, lock the switch trigger and open the chuck
jaws (Fig. 6).
6. The bit provided with the drill can be placed in the storage
area, located on the base of the drill (Fig. 10).
Fig. 10
Selecting the Direction of Rotation
m
WARNING!
Set the direction of rotation selector in the
OFF (center lock) position to lock the switch trigger and help
prevent accidental starting when not in use.
NOTE: Always check the direction of the cordless drill/driver
rotation before use.
1. To select forward rotation, press the forward selector
switch from right to left flat against the cordless drill/driver
(Fig. 11).
Fig. 11
10
Bit storage
Forward rotation selector
