Idiomas disponibles
Idiomas disponibles
4. INSTALLATION AND START-UP OF THE MACHINE
7. MAINTENANCE AND CLEANING OF THE MACHINE
7.4 Importance of cleanliness
4.1 Setting up the machine
For hygiene reasons and correct functioning of the machine, the bowl, guard and spiral mixer must
Position the machine in a place suitable for its intended use which complies with all mandatory
be cleaned every day removing all encrustations. In addition, the entire machine should be dusted to
safety conditions. The area must be equipped with sufficient lighting and aeration.
prevent flour and dirt from building up on the surfaces.
Position the machine observing the minimum distances from walls, as illustrated in fig. 5, to ensure
Such cleaning operations foresee the use of domestic detergent (biodegradable without phosphor or
there is sufficient space for work, cleaning and routine maintenance operations. This will also allow
chlorides) followed by thorough rinsing with water; use a plastic scraper to remove any encrustation.
operators to work in safe conditions, avoiding any crushing and/or being dragged between the bowl
Attention: do not spray water directly on to the machine.
and the wall. When positioned as above, the machine is stable and does not require anchoring to the
floor.
7.5 Cleaning instructions
For safety reasons, all cleaning operations must be performed when the machine is stationary and
disconnected from the mains, following the indications provided below:
Parts to be cleaned
Control Panel
Bowl and spiral mixer
Bowl guard and stand
Base and enclosure casing
7.6 Cleaning the internal parts
4.2 Electrical power supply
The internal parts of the machine must be cleaned at least once a month using a vacuum cleaner, after
The machine is equipped with one single electrical connection with a power cord at the back of the
removing the rear casing.
machine; the system layout can be seen in the diagram supplied with the machine.
Removing the casing allows access to the spiral mixer tool and bowl drive organs. For safety reasons,
Check that the rated plate voltage corresponds to the main network voltage and the rated plate
the removal of the casing for cleaning operations must only take place when the machine is stationary
power is equal or lower than the network power.
and disconnected from the mains.
The connection must foresee coupling to a manual voltage disconnection switch, to allow the
When all the cleaning operations have been completed, fasten the casing in its original position.
separation of the electric machine parts from the mains network when necessary (e.g. during
cleaning or maintenance). This device serves to transmit the correct rated current; the diameter of
the main network connection and external protection (earthing) cables must be proportional and
adequate for the rated current.
Attach a retention plug to the end of the machine power cord suitable for the disconnection switch
installed and plug it into the socket.
Start the machine and check that the spiral mixer turns in the direction indicated by the arrow on the
front of the structure below the bowl. If this is not the case, invert the position of the two phase wires
in the plug. The machine does not require any other type of intervention and is now ready to use.
42
100 cm
Frequency
Every day
Every day
Every day
Every day
10 cm
Use a soft, damp cloth
with detergent
Use a plastic scraper
Use a soft, damp cloth
with detergent
Use a soft, damp cloth
with detergent
What to do
and a damp
35
31
