How To Wire Your Ceiling Fan; Dip Switch; Remote Control - Fanimation AIREFLEX LP7675 Manual

NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote control.
(Figure 1)
NOTE: The remote unit has 32 different code
other remote units, simply change the combination code
NOTE: Factory setting is all up. Do not use this position.
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. (Figure 2)
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
2. Slide the receiver into the hanger bracket before wiring
as shown in figure 3.

How to Wire Your Ceiling Fan

WARNING

Dip Switch

ON
1 2 3

Remote Control

Dip Switch
Receiver
NOTE: Supply wires
omitted for clarity
10
Receiver Unit
4 5
Figure 1
MAIN FUSE BOX
Figure 2
Hanger Bracket
Dip Switch
Figure 3