WARNING
Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service representative.
PROBLEM
Vacuum cleaner
1. Unplugged at wall outlet.
will not run.
2. ON-OFF switch not turned on.
3. Thermal protector tripped.
4. Tripped circuit breaker/blown
5. Defective wall outlet.
Poor job of dirt
1. Dust cover improperly installed.
pickup.
2. Clogged hose or nozzle.
3. Hose not inserted fully.
4. Full or clogged dust bag.
5. Dirty filters.
6. Broken belt.
7. Belt not installed on motor shaft.
8. Worn agitator.
9. Hole in hose.
Dust escapes
1. Bag improperly installed.
the dust bag.
2. Bag torn.
Agitator does not
1. Broken belt.
turn.
Airflow restricted
1. Tool use restricts air flow.
with attachment
use –or– sound
2. New carpet fuzz clogged air path.
changes.
All manuals and user guides at all-guides.com
BEFORE REQUESTING SERVICE
POSSIBLE CAUSE
fuse at household service panel.
- 52 -
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
2. Push ON-OFF switch to ON.
3. Allow to cool 30-50 minutes and
thermal protector will reset itself.
4. Reset circuit breaker or replace
fuse.
5. Check with a good appliance or
lamp. Have outlet properly
serviced.
1. Properly install dust cover.
2. Clean hose or nozzle area.
3. Insert hose.
4. Replace dust bag.
5. Clean or replace secondary filter
and/or replace exhaust filter.
6. Replace belt.
7. Install belt on motor shaft.
8. Replace agitator.
9. Replace hose.
1. Properly install bag.
2. Replace bag.
1. Replace belt.
1. Check tools for fuzz, lint, pet
hair or other debris.
2. See CLOG REMOVAL section
and clean hose.
