Idiomas disponibles
Idiomas disponibles
Programming instructions
1) Programming open & close limits
2) Programming hand transmitters
3) Deleting stored hand transmitters
Opening your life
Opening your life
a) Press and hold SET Button until 1 appears on the display then release the
button.
The door opener is now in Programming Mode.
b) Press and hold the UP until the door reaches the desired open position.
NOTE: Fine adjustments can be made by toggling UP &DOWN buttons
c) Now press the SET button to con rm the position. The display will now
indicate the number 2.
d) Next press and hold the DOWN button until the door reaches the desired
close position. For ne adjustments toggle UP & DOWN buttons.
e) Now press the SET button to con rm the close position.
CAUTION: The door will now cycle open and close to set the travel limits
and force sensitivity adjustments. The door is now set for normal operation.
Caution: After the cycle opens and closes, there will be gures shown on
the display (0-9). "0" means the door is balanced, the smaller the gure
means the better door balance, strongly recommend that the gure needs
to be smaller than the power force.
NOTE: Hand transmitters that are supplied with the door opener are
pre-programmed.
a) Press the CODE button. A dot will be indicated in the corner of the
display.
b) Now press the button on the hand transmitter you want to use, pause
for 2 seconds, then press the same button on the hand transmitter again
for 2 seconds.
The dot on the display will ash to con rm the code, then turn o .
Repeat the process for additional remotes that need to be stored.
Press and hold CODE button until a C is indicated on the display.
All stored remotes will be deleted.
9
Raptor
RP120
Code:
www.accessmatic.com
