Idiomas disponibles
Idiomas disponibles
WF 0243
- Attach the circumference of the front cover (1) inside the other channel of the covering ring.
- Finally tight and secure the screw of the covering ring.
INDICATIONS
- This fan can tilt upwards and downwards by turning and let loose the joint knob (7). It is important to re-
secure this knob after you adjust the settings.
- Using the remote control buttons. Select the function required. The remote control requires
2×AAA batteries.
- To switch on use the remote control power'ON/OFF' (encendido/apagado) button and press the'SPEED'
(velocidad) button to select the airflow required (low, medium, high).
- To oscillate fan, with power on, press the remote control'TURNING (osc)'button.
- The timer can be set from 0.5 hr to 7.5 hrs using the 'TIMER (temporizador)'button on the remote control.
The timer increases in half-hourly increments each time the button is pressed.
- To choose the mode, press the remoe control 'MODE' button. You can change nature, normal or sleep
mode.
SOLUTION TO SIMPLE FAILURE.
-
Always check whether the power plug has been inserted properly into the socket
- Always check whether the fan blade is in contact with other parts such as the protective
Covers (1,5).
- If the fan generates noise or vibrations please check the following:
Fan blade has been installed properly into the motor shaft(6) of the motor.
The back cover (5) has been attached firmly with the motor.
The protective cover is let loose and therefore has been in contact with the rotating blade.
CARE, CLEANING & STORAGE
The fan blade and grill set should be cleaned regularly for most efficient operation. Unplug the fan, then
reserve the assembly procedure to remove those parts from the motor assembly before cleaning. Wipe
with a damp cloth then towel dry.
Never immerse any fan components in water. Wipe the fan only with a dry or slightly moist cloth, then
immediately towel dry.
Always sotre the fan in a cool dry location.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain, and reduce the impact on human health and
the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
10
