Orbegozo AIR 35 Manual De Instrucciones página 12

Idiomas disponibles

Idiomas disponibles

AIR 35
Unplug the power plug, take down the air filter screen (following the same instruction as last point), then
draw the wetted pad from support. Clean the wetted pad with neutral detergent and banister brush. Then
clean it with clear water and reinstall to the appliance.
Attention: the wetted pad must be installed flatly, in order to avoid leaking.
3. Clean the water tank
Unplug the power plug, draw out 1/2 the tank and use soft brush clean it. Use neutral detergent and soft
cloth rub inside of the tank.
Note: if you need to clean the tank completely, you should release the water pump by turning the two clips
that hold it.
4. Clean the shell
Clean with neutral detergent and soft cloth.
Attention: unplug the power plug when clean the appliance. Do not leave any water on the control panel.
MALFUNCITON AND MAINTENANCE
Malfunction
No action
Poor dedusting effect
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected. Consumers should contact their local authority or
retailer for information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
Causes
3. Power
off
or
connection.
4. Not press the "ON" key
on the control panel.
3. Block
the
air
screen with dust.
4. Block the air inlet with
foreign things..
Solution
poor
3. Plug the power cord
and
make
connects well.
4. Press the "ON" key on
the control panel.
filter
3. Purify
the
screen.
4. Remove foreign things
from the air inlet.
sure
it
air
filter
12
loading