Idiomas disponibles
Idiomas disponibles
Cleaning And Maintenance Of The Oven's Front Door Glass
Remove the profile by pressing the plastic latches on both left and right sides
as shown in figure 21 and pulling the profile towards yourself as shown in
figure 22. Then remove the inner-glass as shown in figure 23. If required,
middle glass can be removed in the same way. After cleaning and maintenance
are done, remount the glasses and the profile in reverse order.Make sure the
profile is properly seated in its place.
Figure 21
Catalytic Walls *
Catalytic walls are located on the left and the right side of cavity under the
guides. Catalytic walls banish the bad smell and obtain the best performance from
the cooker. Catalytic walls also absorb oil residue and clean your oven while it's
operating.
Removing the catalytic walls
In order to remove the catalytic walls; the guides must be pulled out. As
soon as the guides are pulled out, the catalytic walls will be released
automatically. The catalytic walls must be changed after 2-3 years.
Rack Positions *
Rack 4
Rack 3
Rack 2
Rack 1
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure, first
remove the lower, and than the upper side from installation location. To install
Figure 22
It is important to place the wire grill into the
oven properly. Do not allow wire rack to touch
rear wall of the oven. Rack positions are
shown in the next figure. You may place a deep
tray or a standard tray in the lower and upper
wire racks.
45
Figure 23
