Idiomas disponibles
Idiomas disponibles
Floor Joist
3. Install the Base
If attached, remove the faucet from the base.
Use a 3/16" drill bit (provided) to drill 1-1/2" (38 mm) deep
holes at the marked locations.
If using concrete as the floor support, use a 3/16" masonry bit
(not provided) to drill 1-1/2" (38 mm) deep holes at the marked
locations.
Realign the base to the position you marked. Make sure the cold
supply notch is in the correct orientation.
Secure the base to the support with the screws and washers
(provided).
Verify the base is level, and tighten the screws.
1443292-2-A
Screw
Washer
Base
3/16"
Mounting Hole
Wood Support
6
Kohler Co.
