Parkside Performance PMFAP 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 23

Getting started
Switching on and off
Switching on
♦ Press the safety lock-out
10 seconds. The LED work
1a
light lights up.
♦ Press and hold the ON/OFF button
♦ To switch on continuous operation, press the
ON/OFF button
Switching off
♦ Press the ON/OFF button
Preselecting the rotation speed
♦ Press the safety lock-out
♦ Set the required speed using the button for
speed preselection
Level 1 = 10,000 rpm
Level 2 = 14,000 rpm
Level 3 = 18,000 rpm
Level 4 = 22,000 rpm
Level 5 = 26,000 rpm
Level 6 = 30,000 rpm
Assembling/disassembling the
cordless multifunction router
♦ Open the corresponding clamping lever
and insert the cordless multifunction router
into the desired module.
–
Edge routing module
–
Routing module
– Angle routing module
The guide groove of the cordless multifunction
router must be aligned with the projection on
the respective router cage.
♦ Close the corresponding clamping lever
.
10
GB │ IE
■ │
. It remains active for
.
twice in quick succession.
.
.
.
9a
Setting the routing depth (router)
WARNING! – RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦ Make sure that the clamping lever
If it is released, turn it anticlockwise until it is
locked.
♦ Place the appliance onto the workpiece.
♦ Rotate the step stop
lowest position (0 mm).
The depth stop is now in line with the lowest
position (0 mm).
♦ Undo the locking screw
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the router bit is touching the surface
of the workpiece.
♦ Lock the clamping lever
clockwise.
♦ Slide the depth stop
reaches the lowest position (0 mm) of the step
stop .
♦ Set the depth stop
depth, tighten the locking screw
NOTE
► The values shown on the routing depth adjust-
ment scale (depth stop)
to the actual routing depth. It should always
be set relative to a selected point on the routing
depth adjustment scale (depth stop)
♦ Now, release the clamping lever
the appliance again.
♦ Check the routing depth by means of a practical
test.
is locked.
until it engages in the
.
by turning it
by turning it anti-
downwards until it
to the desired routing
.
do not correspond
.
and raise
PMFAP 20-Li A1