Idiomas disponibles
Idiomas disponibles
Key
Description
A
Air hose
B
In-line Filter
C
Tee Fitting
To begin using the tool:
1.
As a standard practice, drain water
from the air compressor tank and air
lines prior to use each day
(reference your compressor
operators manual for detailed
instructions).
2.
Install a 1/4" NPT male connector
(not included) into the air inlet port
on the tool (see Figure 2).
Note: Use Teflon® Tape on all
threaded connections.
3.
Turn on the air compressor and
allow it to build up pressure.
4.
Adjust the air compressor's regulator
or the supply line regulator to 90
PSI.
5.
Adjust the torque on the impact
wrench by turning the torque
regulator knob clockwise to the
desired torque setting (1 = minimum
torque/ 3 = maximum torque) (see Figure 2a). Set the torque regulator knob to 3 Figure 2a
(maximum setting) to remove nuts. NOTE: Do not use the air impact wrench
to set torque. Always use a torque wrench to set torque.
6.
Attach the desired 1/2" square drive impact socket.
Always use impact-type sockets and extensions that are
designed for impact wrenches. Hand tool sockets will shatter and potentially
cause personal injury and/or property damage.
Connect the tool to the air hose quick coupler. NOTE: It is recommended that
7.
a whip hose with a swivel (P012-0079SP - not included) be used to prevent
twisting, kinking and excessive wear to the air hose (ref. item "F" in figure
1 for recommended connections).
8.
Select the tool rotation direction. Push the forward/reverse switch to the left for forward or the right for
reverse.
9.
Press the trigger to operate the tool and release the trigger to stop the tool.
Disconnect the tool from the air supply before lubricating or changing sockets.
TYPICAL INSTALLATION
Key
Description
D
In-line Oiler
E
Air Hose
F
Whip Hose
OPERATING INSTRUCTIONS
A 1/2" Square drive
B Trigger
C Exhaust port
D Teflon tape
E Male connector
F Air inlet port
G Torque regulator
H Forward/Reverse switch
Key
Description
G Quick Coupler
H
Male Connector
I
Air Tool
4 - ENG
Figure 1
Key
Description
J
Female Connector
K
Spray Gun
Figure 2
