Idiomas disponibles
Idiomas disponibles
Use
1
Connect the solar panel to the projector.
2
Turn on the projector by setting the switch to ON.
3
Press the mode button to select one of the 3 modes:
MODE 1 :
Motion detector.
The spotlight turns on when someone walks by.
It switches off after 15 seconds if no movement is detected.
MODE 2:
Standby and motion detector.
The projector lights up continuously at low power. It turns on at full power when someone walks by. Then it
switches back to low power if no movement is detected.
MODE 3:
Standby.
The projector illuminates continuously at low power.
Attention !
- To charge your projector more efficiently, please place the solar panel in direct sunlight.
- Before using the projector for the first time, please place it in direct sunlight for several hours.
- If you have not used the projector for an extended period of time, please charge it in direct sunlight for one full day.
- In order to ensure proper battery operation, please place the projector in direct sunlight for one day at least once a
month.
- The battery life and power of your projector may depend on the weather and the location where you have placed the
solar panel. Please make sure it gets enough light.
- When recharging the device, please make sure that the switch is set to ON. Otherwise it will not be able to charge.
- It is recommended to place the solar panel at a height of 2 or 3 m from the ground so that it can properly capture
the sunlight.
- In winter, or on rainy or cloudy days, it is recommended to use your projector in Mode 1 to guarantee its autonomy.
ON and OFF buttons
MODE buttons
Solar panel socket
3
ON/OFF
MODE
Button
Button
