Futurelight PSX-575E Manual Del Usuario página 38

Idiomas disponibles

Idiomas disponibles

Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the PSX-575E starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the PSX-575E can be used without controller.
Disconnect the PSX-575E from the controller and call the internal program.
1. Press [MODE/ENTER] button to enter the main menu "MODE" (display flashing)
2. Press [MODE/ENTER] and select "RUN" by pressing [UP] button.
3. Press [MODE/ENTER] and select "AUTO" by pressing [UP] button.
4. Press [MODE/ENTER] and select "ALONE" by pressing [UP] button.
5. Press [MODE/ENTER] to confirm.
6. Press 3 x [EXIT] to confirm, the display shows "AU-A".
Please refer to the instructions under Control Board, Main functions, menus Run and Edit.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the PSX-575E will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each PSX-575E correctly
and independently from any other fixture on the DMX-chain.
If several PSX-575E are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the PSX-
575E via your lighting controller.
Note:
The modes of DMX 512 data and lamp are shown via the display:
International
L
N
38/103
51839976_V_1_0.DOC
loading