KBS Brita 10-100A Manual Del Usuario página 14

If the connecting cable
follows:
Remove the screw
•
Loosen union nut
•
Loosen connecting cables from the terminal strip
•
Pull the connecting cable
•
For assembly, proceed as follows:
Insert the connecting cable
•
Connect the connecting cables to the terminal strip
•
Note: Ensure correct polarity.
Tighten union nut
•
Close the display housing by replacing the back of the housing
•
screw .
12
The system is now ready for operation.
Note: For commissioning, read the filter system manual. Check system for any leaks.
5 Memory Call-Up
The BRITA FlowMeter enables the data (usage period and the amount of water that has
flowed) of the last 5 filter cartridges to be called up, with the data of the most recent filter
cartridge being stored at memory level 1.
Note: Press the "PROG" button
Press the "PROG" button
•
mode.
In the display
•
8
the "Memory level" field. The amount of water that had flowed before the last filter
change is displayed in running text, alternating with the use period in months.
To access the next memory level up, press the "RESET" button
•
The number in the display shows the current memory level. The data as described for
•
memory level 1 appears in the display.
6 Signalling Exhaustion
When the residual capacity entered has been exceeded, this is displayed in negative and
flashes. If the recommended usage period of 12 months has been exceeded, the residual
capacity flashes.
7 Resetting Litre Information and Time Function
To change the filter, read the filter system manual.
Note: Before bleeding and flushing the filter system, the BRITA FlowMeter must be
reset.
Press the "RESET" button
•
The data time and litre measures have now been reset.
•
Note: The pre-set litre capacity remains.
The filter system is now ready for operation again (Chapter 5)
has to be dismantled to install the display unit, proceed as
11
and open the display housing.
12
.
16
out from the cable screw.
11
into the cable screw of the display unit.
11
on the thread of the cable screw.
16
to leave the memory call-up level at any time.
7
for 5 seconds and the display will change to call-up
7
the 1st memory level is shown; this is shown by displaying the 1 in
for 3 seconds until "RESET" appears in the display
9
.
18
.
18
and tightening the
13
.
9
EN
.
8
11