Idiomas disponibles
Idiomas disponibles
SELF-CLEANING FEATURE
You should use the Self-Cleaning feature to maintain the optimal performance of
your iron. The Self Cleaning feature will clean the water reservoir and steam vents of
accumulated minerals, dust and lint.
TO USE THE SELF-CLEANING FEATURE
1. Hold the Steam Select Lever to the self-clean position and hold for 5 seconds to
remove debris and minerals from the steam valve. This keeps water flowing into the
steam chamber.
2. Fill the water reservoir with tap water to the "MAX" line.
3. Plug in the iron and move the temperature control dial to the "Linen" position, and
allow the iron to heat for two minutes.
4. Unplug the iron.
5. Hold the iron over a sink in a horizontal position.
WARNING: Be careful not to touch the iron's hot surfaces.
6. Set the Steam Select Lever to the self-clean position and hold. Water will begin
dripping from the steam vents. Slowly rock the iron side-to-side and front to back for
30 seconds. When rocking the iron, dip the nose of the iron slightly below the rear to
make certain the water circulates completely.
7. Turn the iron upside down and allow the remaining water to flow out of the fill hole.
8. Dry the soleplate with a towel.
9. Plug in the iron and turn the Temperature Control Dial to the "Linen" position. Let the
iron heat for two minutes and dry out the iron completely.
10. Turn the Temperature Control Dial to the "Off " position. The light will go out,
indicating that the iron has turned itself off. Unplug the iron and allow it to cool before
storing.
GCSTEP2501_GCSTEP2502_20SEM1 (LA).indd 9
E n g l ish -9
5/19/20 6:05 PM
