Foy AR236 Manual De Usuario Y Garantía página 11

Idiomas disponibles

Idiomas disponibles

INITIAL CHARGE OF THE DRILL
The package of the battery has been sent with
a low charge level to avoid possible problems.
Therefore, you will have top charge it at least
for 6 hours before beginning to use it.
TO CHARGE
After a normal use, it requires 3 hours of time
of charge to recharge the battery totally. A
minimum of 6 hours of charge is required to
load a totally discharged battery.
NOTE: The battery package will get lightly
warm during the load. This is normal and it
does not indicate that exists a problem.
• Put the screw driver in the charger.
• The charger can be use with 120 Volt, depend
of each country.
• Connect de charger to the energy source.
• After the normal use, it requires 3 hours at
least to charge.
• Do not put the charger in a cold or hot places.
Will work better with a normal temperature.
DOUBLE COMMAND BUTTON
To use the tool, push the double command
button to the right to screw and to the left to
unscrew.
BLOCKADE BUTTON
Your screw driver has a button (lock) that pre-
vent to push the double command button. This
button prevent future accidents.
WARNING: All the battery rechargeable
tools are ready to be use. So the botton always
have to be lock when you not use the tool or
carry to another place.
WARNING: Always use glasses to protect
your eyes during the operating. Otherwise can
jump object to your eyes causing a damage.
INSTALLING AND REMOVING
SHANK
The mouthpiece of the screw driver is design to
accept hexagonal tips ¼'' (6.35 mm).
E N G L I S H •
HOW TO INSTALL THE TIPS
• Insert the tip in the mouthpiece.
• Once your finish the work, take of the tips of
the mouthpiece.
MAINTENANCE
WARNING: It's recommended that all repa-
rations been made by an authorized service
center.
WARNING: Before to clean or realize any
kind of maintenance, the tool must be un-
plugged of the power source. The ventilation
slots must be kept clean. Don't try clean it
introducing sharp objects trough ventilation
slots.
WHAT TO DO WITH A WASTED BATTERY
To conserve the natural resources, recycle or
eliminate the batteries properly. This product
contain a nickel and Cd battery. Must eliminate
in the right way. The locals laws, can prohibit
throw the batteries in the common garbage.
Ask to the local person to get information
about recycling batteries or how to eliminate
this products.
EXTRACTING THE BATTERY PACK
TO REMOVE: Push the end/bottom of the screw
driver and slide smoothly until retire the nickel
and cadmium battery.
TECHNICAL DATA
BATTERY
CHARGER INPUT
CHARGER OUTPUT
SPEEDS
SHANK CAPACITY
U se r 's m a nu a l
3,6 V
120 V ~ 60 Hz 5,3 W
6 V
250 mA
250 r/min
1/4" (6,35 mm)
11
loading