Idiomas disponibles
Idiomas disponibles
Fuse
WARNING!
Before servicing, repairing, or
inspecting, always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
A fuse is installed in your tractor's wiring harness to protect the
tractor's electrical system from damage caused by excessive
amperage.
If the electrical system does not function, or your tractor's engine
will not crank, check to be certain that the fuse has not blown. It
is located under the hood, mounted behind the top of the dash
panel on the support bar.
CAUTION:
Always use a replacement fuse with the
same amperage capacity as the blown fuse.
Tires
WARNING!
Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to mow
unevenly.
Changing the Transmission Drive Belt
Several components must be removed and special tools used in
order to change the tractor's transmission drive belt. See your
Cub Cadet dealer to have the transmission drive belt replaced.
Changing the Deck Belt
WARNING!
Shut the engine off and remove
ignition key before removing the cutting blade(s) for
sharpening or replacement. Protect your hands by
using heavy gloves when grasping blades and
pulleys.
WARNING!
The V-belts found on your tractor are
specially designed to engage and disengage safely.
A substitute (non-OEM) V-belt can be dangerous by
not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present. To change or replace
the deck belt on your tractor, proceed as follows:
1.
Remove the deck as instructed on page 24.
2.
Remove the belt guards by removing the hex screws that
fasten them to the deck. See Fig. 7-8.
Belt Guards
Figure 7-8
3.
Loosen, but do not remove the belt keeper rod on the
pulley located near the back of the deck. See Fig. 7-8.
4.
Carefully remove the deck belt from around the three
spindle pulleys and the two deck idler pulleys.
Belt Keeper Rod
Hex Screws
Deck Idler Pulley
S
7 — S
ection
ervice
25
