Concept NO8010 Manual Del Usuario página 25

EN
360° rotary hanger
Important safety information: Always attach and remove the attachments to the appliance that is switched OFF
and cool!
BEFORE FIRST USE
1. Make sure that the appliance is unplugged and the switch is in the OFF position.
2. Remove the water tank. Remove the cap and fill the water tank with cold water. Reinstall the water tank into the
appliance.
Important notice:
To ensure maximum lifetime of the appliance, we strongly recommend using only distilled or
•
demineralized water.
If you live in an area with hard water, limescale will clog the appliance and reduce its
efficiency.
• Use only cold water (never hot)!
• Never use the appliance without properly filled water tank! It may lead to irreversible damage to the appliance.
USE
1. The appliance must remain horizontal on the floor.
2. Plug in the appliance.
3. Place the selected garment on the rotary hanger.
4. Turn the main switch to switch on the appliance and select the desired steam output.
5. After approximately 45 seconds, steam starts to come out.
6. For optimal use, let steam flow from top to bottom over your garment.
7. If water runs out during use, switch off the appliance and refill the water tank according to the instructions.
Hold
48
360°
Hold
NO8010
AFTER USE
1. Switch off the appliance by switching the main switch to the OFF position.
2. Disconnect the appliance from the mains.
3. Let the appliance cool down for at least 30 minutes.
4. Remove the steam hose and shorten the telescopic rod.
5. Remove the water tank and empty it.
6. Rinse the water tank with fresh water and let it dry.
7. Drain the remaining water through the drain plug at the bottom of the appliance.
HOT
DESCALING
Important information:
• Apply as needed after about 10 uses of the appliance. However, at least once a month.
• After the last use, wait at least 1 hour for the appliance to cool down completely.
1. The appliance must be switched off and disconnected from the mains.
2. Remove the steam hose and the telescopic rod.
3. Remove the water tank.
4. Dry the water tank inlet.
5. Pour approximately 0.5 l of vinegar solution into the water tank inlet (part vinegar + part water).
6. Gently shake the appliance and let it stand for about 40 minutes.
7. Then drain the solution through the drain plug into a kitchen or a bathroom sink.
8. Rinse the steam hose connection and the water tank inlet with clean water. Repeat as needed until the vinegar
odour disappears.
9. Close the drain plug and store the appliance in a safe place.
TROUBLESHOOTING
This chapter lists the most common problems you may encounter when using the appliance. If the instructions below do
not help you to solve the problem, contact the Jindřich Valenta - Concept company service department.
NO8010
EN
49