Features; Operation Instructions - Surtek CC407A Manual De Usuario

Cortadora de ceramicos
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

· Give your work undivided attention. Look-
ing around, carrying on a conversation, and
"horse-play" are careless acts that can result in
serious injury.
· Ensure that the directional arrow marked on
the blade corresponds with the rotational di-
rection of the motor.
· With
the machine disconnected from the
power supply, rotate the blade by hand to en-
sure it is free from obstruction.
· Always keep the blade securing arbor and
collars clean.
· Ensure that the blade-securing bolt is secure-
ly tightened with a suitable wrench.
· Never try to cut freehand. Always ensure that
the tile to be cut is pressed firmly against the
parallel side fence.
· Ensure that the work piece to be cut off has
sufficient room to move sideways. Failure to do
so may result in the off cut binding against the
blade.
IMPORTANT: Never cut more than one tile
at a time.
· Never cut pieces too small to be held securely
against the side fence without leaving enough
space for the hand to be a safe distance from
the blade.
· Ensure that the table and surrounding area
are clear with the exception of the tile to
be cut.
· Never fit substandard blades to the machine.
Only fit correctly sized diamond blades.
· Before cutting a tile piece let the saw blade
run freely for a few seconds. If it makes an
unfamiliar sound or vibrate excessively switch
it off immediately and disconnect from the
power supply. Investigate the cause or consult
a qualified person for advice.
· Let the blade reach full speed before com-
mencing the cut.
· Do not force the blade to cut the tile.
· Let the blade come to a complete stop be-
fore removing any jammed or off cut material
from around the blade area.

FEATURES

KNOW YOUR TOOL
Before attempting to use this tile cutter, be-
come familiar with all of its operating features
and safety requirements.
10
WARNING: Do not allow familiarity with
the tile cutter to cause carelessness.
Remember that a fraction of a second of care-
lessness is enough to inflict severe injury.
1. WATER CONTAINER.
2. PARALLEL GUIDE.
3. BLADE GUARD COVER.
4. 45˚ ANGLED MITRE GUIDE.
5. TABLE.
6. ON/OFF SWITCH.
4
2
5
6

OPERATION INSTRUCTIONS

This portable electric tile cutter can be used to
cut tiles of small and medium size in ceramic,
marble, stoneware, earthenware and similar
materials.
FITTING THE PARALLEL GUIDE
Position the parallel guide on work table. Align
the holes in the fixing plates with the holes in
the upright ends of the parallel guide, fix it
with the securing knobs provided.
NOTE: The fixing plate should be fitted on the
outside surface of the work table edges.
NOTE: Before use, the blade guard bracket and
blade guard must be fitted to the cutter.
OPERATING/STARTING AND STOPPING
To start the cutter, plug the tile cutter to
the main power supply. Press switch in the ON
posi- tion to start (marked "I"). Press switch
OFF to stop it (marked "O").
FILLING THE WATER TRAY WITH WATER
Before the cutter can be used the water tray
must be filled. When removing machine from
packaging, the water tray is stored inside the
3
1
Tabla de contenido
loading

Tabla de contenido