Idiomas disponibles
Idiomas disponibles
Assembly
• Save all instructions
Read and follow the assembly instructions. Do not discard
any parts or materials until the unit is assembled.
References to the right or left side of the trimmer are from
the viewpoint of the operator's position behind the trimmer.
WARNING
Do not operate trimmer if it is damaged or not completely
and correctly assembled.
Before doing any assembly or maintenance to the unit,
remove the wire from the spark plug. The following compo-
nents will be found in the carton. Quantities shown in ( ).
Included Parts in the Carton
1
Operator Manual
2
Engine Manual
3
Start Guide
4
Wing Nuts
5
Handle Bolts
6
Flange Nut
7
Hub Cap
8
Two Wheels
9
Upper Handle
10
Trimmer assembly
11
Set of 0.155in. (4mm) Trimmer Line
12
Cable Ties
13
Container of Engine Oil
Assemble the Handle
NOTE: Refer to Figure 2 when following the steps below
1. Attach upper handle assembly to lower handle by aligning
bolt holes and inserting provided handle bolts through
each side and assembling plastic wing nut.
Assemble the Control Cable to the Control Lever
NOTE: Refer to Figure 3 when following the steps below
After the handle has been assembled, install the control
cable as follows:
1. Insert z-hook into hole in the control lever
(insert from inside to outside).
2. Clip retainer into hole in handle.
3. Secure control cable to handle with cable ties as desired.
4. To attach the recoil starter handle to the rope guide,
engage control lever, pull rope, twist the rope through the
rope guide mounted on the right side of the handle.
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
QTY
1
1
1
2
2
1
2
1
1
1
2
2
1
Control Lever
Z-hook
Control cable
Clip retainer
EN - 7
Recoil Start
Handle
Rope Guide
Handle
Bolt
Steel
Spacer
Copyright © 2018 MAT Engine Technologies, LLC
Handle
Wing Nut
Wheel
Hub Cap
Flange
Nut
Figure 2
Figure 3
