Idiomas disponibles
Idiomas disponibles
Installation
1
Removing the mounting
bracket
□
Remove the two decorative fixture nuts (CC)
from the light fixture (A).
□
Remove the mounting bracket (EE) from the
light fixture (A).
2
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
□
Remove the existing light fixture.
□
Tighten the two large mounting screws (DD)
finger tight into the mounting bracket (EE).
□
Attach the mounting bracket (EE) to the
junction box (not included) securely with the
two mounting bracket screws (AA).
□
Firmly pull on the mounting bracket (EE) to
verify it is securely mounted to the junction
box. If necessary, use the screws that were
removed from the existing light fixture.
3
Changing the mounting
bracket orientation
NOTE: This fixture comes with a universal mounting
bracket. It is pre-assembled on the fixture to fit the
majority of junction box applications.
NOTE: The wire path on the mounting plate must be
located as shown below to allow the wires on the back of
the fixture to pass through.
If the slots on the mounting plate (EE) do not line up
with the junction box screw holes, follow these steps:
□
Remove the two large mounting screws (DD)
from the mounting plate (EE). DO NOT remove
the ground screw (1).
□
Attach the ground wire "pigtail" to the ground
screw (1) on the mounting plate (EE) (See
Recommended Grounding Method under step
4 for additional information).
A
DD
AA
□
Flip the mounting plate (EE) over.
□
Rotate the mounting plate (EE) so the wire path
is on the upper right.
□
Reinstall the large mounting screws (DD) and
attach the mounting plate (EE) to the junction
box as shown.
1
Wire
Path
DD
As Shipped
5
Please contact 1-855-HD-HAMPTON for further assistance.
CC
DD
EE
1
EE
Wire
Path
DD
Flipped and Rotated
HAMPTONBAY.COM
EE
DD
