Safety instructions
General installation terms and condition
1. Read the instructions.
2. Keep these instructions.
3. Pay attention to all warnings.
4. Follow all the instructions.
5. Do not use this equipment close to water.
6. Clean with a dry cloth only.
7. Do not block vents. Install according to the manufacturer' s
instructions.
8. Do not install close to sources of heat. Avoid environments
with strong electromagnetic signals, vibrations, dust or
direct sunlight.
9. Only use attachements/accesories speci ed by the
manufacturer.
10. Request all repairs from quali ed service personnel.
Request a repair when the equipment is damaged in
any way, such as damage to the main cord or plug;
liquid spills or if any object has fallen inside the
equipment; or if the equipment has been exposed to
rain or moisture, does not work properly or has fallen.
Warning
•
This equipment should not be dropped or splashed by
water. Do not place objects or containers lled with
water, such as vases, over or close the equipment.
How to use the equipment safely
•
In case any liquid or object falls inside the equipment you
should contact the technical service.
Safe installation
•
Room temperature must not exceed 40ºC.
•
Do not place the equipment close to sources of heat or in
environments with high humidity levels.
•
Do not place the equipment where it may be subject to
strong vibrations or jolts.
•
Leave a free space around the equipment for proper
ventilation.
•
Do not place sources of naked ames, such as lit candles,
over the equipment.
DECLARACIÓN DE CONFORMIDAD DECLARATION OF CONFORMITY DECLARAÇÃO DE CONFORMIDADE DECLARATION DE CONFORMITE
DICHIARAZIONE DI CONFORMITÀ DEKLARACJA ZGODNOŚCI KONFORMITÄTSERKLÄRUNG ΠΙΣΤΟΠΟΙΗΤΙΚΟ ΣΥΜΜΟΡΦΩΣΗΣ FÖRSÄKRAN OM
ÖVERENSSTÄMMELSE ДЕКЛАРАЦИЯ СООТВЕТСТВИЯ
Fabricante / Manufacturer: Televés S.A.U. Rúa B. de Conxo, 17 - 15706 Santiago de Compostela, A Coruña. Spain www.televes.com
2021 © Copyright, Televés S.A.U.
Symbology
s
Troubleshooting
•
Power LED is not lit
Check if the power connector is connected properly.
Try disconnecting and reconnecting the power supply.
•
Link LED is not lit.
Make sure the device's network connection settings are
correct and check that the drivers on the device's network
card are up to date.
•
Check the distance between connections.
Make sure that the connection distance between the
switch and any other connected device, compatible with
the IEEE 802.3 standard, does not exceed 100 m.
•
Performance is low.
Check the communication status between devices. If one
-
device sets the Full-Duplex protocol but another device
sets the Half-Duplex protocol, the performance of that
link will be poor.
Make sure that the connections between the switch and
-
the di erent devices are made with CAT.5 or higher UTP
cables.
•
Devices cannot communicate.
Check the status of the "Link" LED to make sure the
-
devices are connected.
Make sure that the network settings
-
of the devices are correct.
Reset the switch if necessary.
-
https://doc.televes.com
ةقباطملا نايب
Designed for indoor use only.
Meets EC marking requirements
This product cannot be treated as normal
domestic waste. It must be taken to a waste
electrical and electronic equipment colletion
point (WEEE).
768111_004_ES-EN
